Secondary Functions

DEST

---

Destination page accessed via ICP LIST 1. It also has 2 subpages which are accessed via DCS SEQ.

DEST DIR

• Changing STPT via the ICP rocker switch or manually through the ICP will not change currently selected STPT.
• LAT N
  • Selected STPT Latitude, which can be edited with the Scratchpad.
• LNG E
  • Selected STPT Longitude, which can be edited with the Scratchpad.
• ELEV
  • STPT elevation, which can be edited with the Scratchpad.
• TOS
  • Time on Station

DEST OA1

---

Creates offset aimpoints at the selected STPT and is typically used with computed bombing profiles via the WDP (Weapon Delivery Planner). As such it will be covered in the WDP Wiki article.

BNGO

---

Bingo fuel warning settings accessed via ICP LIST 2. STPTs can be cycled via the ICP rocker switch while in this page.

• SET
  • Sets Bingo fuel value. When total fuel goes below this value the VMS will alert 'Bingo, bingo' and a FUEL message will flash on the HUD. Inputting a lower value will extinguish the VMS and HUD warnings, as will pressing the HUD WARN RESET switch on the ICP. Bingo warning will only occur when the FUEL QTY SEL knob is set to NORM.
• TOTAL
  • Displays current total fuel.

VIP

---

Accessed via ICP LIST 3 and has one subpage accessed via DCS SEQ. These two pages are used for computed bombing profiles with the WDP and will be covered in the WDP Wiki Article.

INTG

---

Accessed via ICP LIST RCL. Part of IFF, which is not implemented.

NAV

---

Accessed via ICP LIST 4. Not implemented.

MAN

---

Accessed via ICP LIST 5 and edits the wingspan value associated with the EEGS funnel gunsight.

INS

---

INS alignment information accessed via ICP LIST 6. STPT can be cycled with ICP rocker switch while in this page.

• INS
  • Current alignment. 8.0/10 is the minimum needed for complete INS alignment without GPS.
• LAT N
  • Current Latitude, which can be edited with the Scratchpad.
• LNG E
  • Current Longitude, which can be edited with the Scratchpad.
• SALT
  • Current altitude
• THDG
  • Current heading
• G/S
  • Current ground speed

DLNK

---

Datalink page accessed via ICP LIST ENTR and subpage accessed via DCS SEQ. STPTs can be cycled with the ICP rocker switch while in this page. See Datalink Wiki article for details.

EWS

---

Accessed via ICP LIST 7 and has two subpages accessed via DCS SEQ.

CMDS BINGO

• Turns bingo warnings on or off and sets bingo values for chaff (CH) and flares (FL) with the Scratchpad.
• STPTS can be cycled while in this page.
• Can only be edited when the CMDS MODE is set to STBY.

CMDS CHAFF

---

Can only be edited with the CMDS MODE set to STBY.

• PGM
  • Cycles Programs 1-6 via the ICP rocker switch.
• BQ
  • Burst Quantity, edited with the Scratchpad.
• BI
  • Burst Interval in seconds, edited with the Scratchpad.
• SQ
  • Salvo Quantity, edited with the Scratchpad.
• SI
  • Salvo Interval in seconds, edited with the Scratchpad.

CMDS FLARE

---

Same as CMDS CHAFF.

MODE

---

Accessed via ICP LIST 8. Not implemented.

VRP

---

Accessed via ICP LIST 9 and has one subpage accessed via DCS SEQ. Used for computed bombing profiles with WDP and will be covered in WDP Wiki article.