Difference between revisions of "Getting started with GCI/AWACS"

From DCS World Wiki - Hoggitworld.com
m
(lotATC)
Line 222: Line 222:
 
}}</center>
 
}}</center>
  
==== lotATC ====
+
==== LotATC ====
Coming soon
+
LotATC is an optional program one can use to facilitate GCI simulation. The program is fairly easy to use is highly customizable. LotATC provides many features to aid a GCI.
 +
 
 +
* The creation of persistant BRAAs
 +
* IFF features
 +
* An ATC mode
 +
* The ability to call BRAAs from the bullseye
 +
* A scale which can be used to respond to Picture calls
 +
* The ability to draw on the map
 +
 
 +
For more information on LotATC and how to use the software see [[https://wiki.hoggitworld.com/view/LotATC LotATC]]
  
 
== Coordinating with human GCI/AWACS ==
 
== Coordinating with human GCI/AWACS ==

Revision as of 20:28, 15 February 2020


Disclaimer
This guide is compiled using information available to the public and information based on personal experience in DCS World. This guide does not in any way, shape or form represent real life GCI/AWACS operations or techniques nor is it based on real life experience.

What is GCI/AWACS

Boeing E-3 Sentry

GCI stands for Ground-Controlled Interception, an air defence tactic which developed during World War I. One or more radar stations or other observational stations are linked to a command communications centre which guides interceptor aircraft to airborne targets.

Today, GCI has mostly been replaced by Airborne Early Warning and Control (AEW&C) aircraft or more commonly referred to as AWACS (Airborne Warning And Control System). While AEW&C is expensive and vulnerable in comparison to GCI systems, it has a mobility advantage. In reality a combination of both systems is often used.

AWACS aircraft are generally speaking big, modified planes with a long-range radar mounted on top. The main radar antenna is mounted on a turntable housed in a circular rotodome, which is 9m (30 feet) in diameter, elliptical in cross-section and 1.8m deep at its centre. The radar system can detect, track and identify low-flying aircraft at approximately 370 km (200 nautical miles) and high-level aircraft at much greater distances.

AI AWACS in DCS World

In DCS World the NATO AWACS comes in the form of the Boeing E-3 Sentry and the Russian equivalent is the Beriev A-50. The player can contact the allied AWACS via the ingame comms menu on the specified frequency in the mission briefing.

Comms menu

Vector to bullseye
The AWACS will provide the player with a bearing and range to bullseye
Vector to home plate
The AWACS will provide the player with a bearing and range from bullseye to their home airfield
Vector to tanker
The AWACS will provide the player with a bearing and range from bullseye to the tanker
Request BOGEY DOPE
The AWACS will provide the player a BRAA call to the closest airborne threat.
Request PICTURE
The AWACS will provide the player with BRA calls for each group from bullseye
DECLARE
The AWACS will identify friend or foe of a radar locked target

Understanding BRAA calls

Figure 1

BRAA stands for Bearing Range Azimuth Aspect from your current location.

BRA, 183 for 10 at 2000, hot
would mean the target is located at 183 degrees, 10 nautical miles, at 2000 feet coming directly at you. For aspect see figure 1.

Understanding bullseye

Bullseye is a fixed point on the map determined pre-mission. All allied aircraft can relate to this point. When receiving a bullseye call, simply use the BRA format with bullseye as starting point. Bullseye in DCS is represented with the following symbols

Left:Bullseye representation in DCS World - Right: Bullseye details

Human GCI/AWACS

In DCS World, players can take the role of GCI/AWACS on multiplayer servers to assist your fellow pilots and friends. In the following sections we’ll go over the basics of airspace management, threat assessment, callsigns, brevity and some useful tools.

Before you begin as a GCI/AWACS controller on a server go over this short checklist:

  • Pick a suitable callsign
  • Check and confirm the radio frequencies used for GCI/AWACS, general communications and air traffic control
  • Tune in the correct frequencies on SRS
  • Be in the correct server slot
  • Have your tools set up and running
  • Announce GCI/AWACS will be available over COMMS and CHAT. State the correct frequency and callsign
all flights on frequency be advised <callsign> will be available on <frequency> for GCI/AWACS
  • If you are on the Hoggit Discord and registered as a GAW GCI controller, use the !gci sunrise <callsign> command

Airspace management

As a controller your goal is to manage both friendly and hostile airspace. You’ll want to direct your allied flights to intercept enemy threats while at the same time making sure your friendly airspace stays protected.

Divide the airspace you’ll be controlling into two sectors.

  1. a friendly sector
  2. a hostile sector


Divide sector 1, your friendly sector, into subsectors based on strategic locations like airfields or a FARPs.

Next, you can assign your available CAP flights to the subsectors you created, and have them patrol or set up orbit. This way you can ensure that

  • your allied flights are in proximity to allied aircraft and able to support
  • your allied aircraft are not spread out or alone in hostile airspace
  • your allied aircraft are in range of a tanker or airfield
  • your friendly sector is protected

Threat assessment

With your airspace divided into sectors and your CAP flights on station you can start intercepting enemy threats. There are 2 major things you want to pay close attention to at all times.

  • Where are your allied aircraft in relation to your sectors
  • Where are the enemy aircraft in relation to your sectors


Before making a decision to direct your allied flights to intercept, you want to assess the threat

  1. Distance: what is the distance between the threat and the nearby sector or allied aircraft
  2. Number: how many enemy aircraft make up the threat
  3. Type: which type is the enemy threat
  4. (State): have they been engaged prior and thus used counter measures and/or weapons


When you have gathered this info you can make a decision to either:

  • direct one or more allied aircraft to intercept the threat
  • direct one or more aircraft away from the threat to nearby SAM cover
  • direct one or more allied aircraft to support engaged allied aircraft


In case you are unsure and need extra information before making a decision, contact your allied flights and ask for a fuel and/or weapons state.

When directing your allied flights to intercept, try to keep them in proximity of other allied flights, so you have enough time to send in support if needed. Do not direct your allied flights into enemy airspace and SAM range without support.

Callsigns and radio communication

When acting as GCI/AWACS controller you want to make sure you have a callsign which

  • is clear
  • is easy to pronounce
  • does not cause confusion
  • is not ridiculous


Commonly used callsigns for GCI/AWACS are

  • Overlord
  • Magic
  • Showtime
  • Darkstar
  • Goliath
  • Wizard
  • Griffin
  • Bigfoot


As GCI/AWACS controller you’ll have to relay a lot of information in a clear, concise and easy to understand manner, usually in a short amount of time. It is important to have a good microphone set up, to speak loud and clear, articulate, not to speak too quickly and use the NATO phonetic alphabet to avoid confusion. We’ll discuss some examples below.

Responding to flights checking in

When allied flights switch to general comms or designated AWACS comms after take off, they’ll most likely check in on the frequency and let you know who they are and what their intentions are.

Flight - “Magic, Uzi 1-1, single flight F18, 10 miles North of Anapa, checking in for CAP”

In the above example a player lets you know who they are, where they are and what their intentions are. You can respond to acknowledge (and task them if desired).

AWACS - “Uzi 1-1, Magic, Lima Charlie, standby for tasking”
AWACS - “Uzi 1-1, Magic, Lima, Charlie, fly heading 100 for 20, anchor at Krymsk”

Directing allied aircraft to intercept

When directing aircraft to intercept you want to be clear and concise. Start with who you are talking to, who you are and provide a BRA(A) call (and optional additional information). It is important to pronounce heading as single digits. For example ‘100’ would be ‘one, zero, zero.’

AWACS - “Uzi 1-1, Magic, BRA 100 for 40, at angels 15, flanking”
AWACS - “Uzi 1-1, Magic, BRA 100 for 60 at 500 feet, hot, 2 ship type MiG-29”

Responding to a Bogey Dope request

When a player asks for a Bogey Dope, they are asking for the nearest hostile. Locate the aircraft who made the request, and provide them a BRA to the nearest hostile.

Flight - “Magic, Uzi 1-1, Request Bogey Dope”
AWACS - “Uzi 1-1, Magic, BRA 257 for 15, at angels 10, cold”

When there are no hostile aircraft on scope

AWACS - “Uzi 1-1, Magic, Picture Clear”

Responding to a DECLARE request

When you receive a DECLARE request, you are asked to identify friend or foe of a locked target.

Flight - “Magic, Uzi 1-1, DECLARE 204, for 8”
AWACS - “Uzi 1-1, Magic, hostile/friendly”

Miscellaneous

Sometimes you will need to ask for additional information, or provide additional information.

Return to base (RTB)

Flight - “Magic, Uzi 1-1, winchester RTB”
AWACS - “Uzi 1-1, Magic, Roger, fly heading 010 for 35”

Ask for fuel state

AWACS - “Uzi 1-1, Magic, state fuel”

Inform aircraft to wait for instructions

AWACS - “Uzi 1-1, standby”

Ignore last transmitted message/instructions

AWACS - “Uzi 1-1, Magic, disregard last”
AWACS - “Uzi 1-1, Magic, BRA 070 for 5, disregard, BRA 090 for 5, at angels 7, hot”

Identify unknown transmitting aircraft

Flight - “Magic, request Bogey Dope”
AWACS - “Last transmitting aircraft, state callsign”

Inform aircraft about incoming missiles or missile launches

AWACS - “Uzi 1-1, DEFEND”
AWACS - “Uzi 1-1, missile launch, 9 o’clock, go defensive”
AWACS - “Uzi 1-1, SAM launch, 12 o’clock go defensive”

Tools

SRS AWACS mode (eam)

The standard SRS radio overlay only displays up to 3 radios and 1 intercom. The AWACS overlay provides up to 10 radios, which you can manually tune and 1 intercom.

You can use SRS without running DCS World, by using the external AWACS mode (EAM). provide your EAM username and the EAM coalition password. The coalition password is provided by the server admin, or in the server briefing. This is not always available.

F10 map, icons and the ruler tool

The ingame F10 map is where you’ll spend most of your time doing GCI/AWACS. It provides several functions which you can toggle on or off by personal preference

  • health bars
  • SAM and AAA detection range indicators
  • SAM and AAA engagement range indicators
  • grid
  • labels indicating type and name
  • ruler tool


The most important function you’ll use is the ruler tool. It allows you to create a line from point A to point B and provides you with the length in nautical miles and the heading. When intercepting enemy aircraft you can use the ruler tool to draw a line from your allied aircraft A to the hostile aircraft B and read the distance in nautical miles and the heading indicated on the top bar. When you click on the enemy aircraft icon, you can read its altitude, speed in knots, heading and type on the bottom left.

LotATC

LotATC is an optional program one can use to facilitate GCI simulation. The program is fairly easy to use is highly customizable. LotATC provides many features to aid a GCI.

* The creation of persistant BRAAs
* IFF features
* An ATC mode
* The ability to call BRAAs from the bullseye
* A scale which can be used to respond to Picture calls
* The ability to draw on the map

For more information on LotATC and how to use the software see [LotATC]

Coordinating with human GCI/AWACS

A couple guidelines from the players point of view

Inform AWACS when you tune in or tune out of the AWACS frequency.

Flight - “Magic, Uzi 1-1, single flight F18, 10nm North of Anapa, checking in for CAP”
Flight - “Magic, Uzi 1-1, type Mirage 2000, checking in for CAP”
Flight - “Magic, Uzi 1-1, bingo fuel, RTB”
AWACS - “Uzi 1-1, Roger, fly heading 100 for 35”

Do not clutter the AWACS frequency with off-topic chatter, use the correct frequencies as stated in mission briefing.

Do not read back a BRA call. Simply acknowledge you received and understood the message by saying your callsign. If you did not understand the transmission, ask AWACS to repeat.

AWACS - “Uzi 1-1, Magic, BRA 100 for 45, at angels 20, flanking”
Flight - “Uzi 1-1”
Flight - “Magic, Uzi 1-1, repeat last”